Keg carbonation confusion

The ins and outs of putting your beer into kegs.

Keg carbonation confusion

Postby bilgerat » Wednesday May 25, 2011 12:07 pm

Hello fellow brewers.I am new to kegging beer after several years of brewing into bottles.
I have just kegged my first brew, a Coopers Irish Stout which is ok but Im a bit confused with carbonating the keg.There are several methods of carbonating a kegs on various websites, the method I used for my first one was to fill the keg from the fermenter, I then put a small amount of CO2 into the keg and burped it through the relief valve and put it in the fridge overnight, once the keg was cold I put the CO2 into the keg at about 300kpa (40psi)for several days, three or four times a day I would top up the gas and give it a good shake and watch the gas pressure drop due to shaking the brew then top up the gas back up to 40psi etc.

My brew is a bit gassy when I pour it, I have dropped the pressure down to about 100kpa(15psi) my question is will I need to bump the pressure up to 40psi again to keep the brew carbonated, will it go flat if it is left at 15psi all the time, I only have the gas turned on when pouring the beer other that that the gas is left off in case of leaks etc.

Thanks for any replies
bilgerat
User avatar
bilgerat
 
Posts: 105
Joined: Tuesday May 24, 2011 6:58 pm
Location: Perth Western Australia

Re: Carbonating Kegs and leaving

Postby lethaldog » Wednesday May 25, 2011 1:53 pm

No it wont go flat, what your doing is force carbing so you can get it done quicker, if you left your brew at 15 psi for a couple of weeks you would pretty much get the same result although it sounds like you may have overdone it just a little but once your beer is carbonated then just leave at pouring preasure and it will be fine!!
Cheers
Leigh
User avatar
lethaldog
 
Posts: 2716
Joined: Wednesday Jul 19, 2006 11:13 am
Location: Victoria

Re: Keg carbonation confusion

Postby squirt in the turns » Thursday May 26, 2011 12:10 pm

What can be done about an over-carbonated keg? I'm guessing letting it warm up a bit to get some CO2 to come out of solution, then burping it would be one way, but too many temperature changes are never good for a brew.
User avatar
squirt in the turns
 
Posts: 274
Joined: Thursday Dec 04, 2008 8:26 pm
Location: Gold Coast

Re: Keg carbonation confusion

Postby Tipsy » Thursday May 26, 2011 1:45 pm

squirt in the turns wrote:What can be done about an over-carbonated keg? I'm guessing letting it warm up a bit to get some CO2 to come out of solution, then burping it would be one way, but too many temperature changes are never good for a brew.


Just leave it in the fridge and burp it every now and again, no need to let it warm up
User avatar
Tipsy
 
Posts: 1463
Joined: Saturday Jun 18, 2005 12:49 am
Location: Sth. Gippsland, Victoria

Re: Keg carbonation confusion

Postby hirns » Saturday May 28, 2011 7:06 am

squirt in the turns wrote:What can be done about an over-carbonated keg? I'm guessing letting it warm up a bit to get some CO2 to come out of solution, then burping it would be one way, but too many temperature changes are never good for a brew.


Adding to Tipsy's comment (and you should use a check valve to prevent beer going into your reg) I burp it down to about 5psi. I then turn off the gass at the bottle and use the fact that its overgassed to pull a beer. In between beers if the reg has risen back up to say 15psi then I burp it back down to 5psi before pulling a beer. I often pull these beers into a jug to let the head settle if it is really overgassed. When the beer's co2 level gets to where you want it, turn the gas back on at normal serving pressure.

Cheers :D

Hirns
hirns
 
Posts: 327
Joined: Tuesday Apr 28, 2009 8:33 pm
Location: Yeppoon QLD

Re: Keg carbonation confusion

Postby squirt in the turns » Saturday May 28, 2011 12:40 pm

Cool, thanks guys.
User avatar
squirt in the turns
 
Posts: 274
Joined: Thursday Dec 04, 2008 8:26 pm
Location: Gold Coast

Re: Keg carbonation confusion

Postby speedie » Tuesday Jun 07, 2011 9:54 pm

with all that burping going on it sounds like you all have young kids
not kegs
as oliver said i would push as much co2 into your brew then cold settle
but if it was me then again the beer would be coming out of the fridge at 1 degree be transfered to a cleaned co2 flushed vessel
then carbonated asap
bonus is you get to try your brew straight away
and dont have to worry about pressure drop
cheers speedster :D
speedie
 
Posts: 622
Joined: Monday Aug 16, 2010 11:53 am


Return to Kegging

Who is online

Users browsing this forum: No registered users and 18 guests