HomebrewandBeer.com forum

Placed a brew in keg a couple of days ago , was all going well , but now it seems to have gone flat , keg still seems round half full , ( DID GIVE IT A FAIR NUDGE FIRST NIGHT ) this being my first attemp at homebrewing , just need a little advice . on what could be wrong , have read instructions
over and over regarding preasure ect , have it set round 8 psi ,
would appreciate any help whatsoever .

Are you leaving the gas hooked up the whole time or just when pouring?

Also, the keg is staying in the fridge & not being moved around or anything? Temperature affects how much CO2 will stay in solution.

Sounds like you may have a leak someware most likley thew keg lid o ring not seated properly.

Put 200 kpa in the keg and check for any leaks.

You can re-gas the beer if it has gone flat.

Have found that beer was starting to freeze . This could be the problem I think .