Frothy Beer

The ins and outs of putting your beer into kegs.
Post Reply
droverz
Posts: 2
Joined: Monday Nov 18, 2013 3:38 pm

Frothy Beer

Post by droverz »

Hi all. I am new to this site and new to brewing. I have a keg set up with a Cornelius keg and a 10kg Co2. I have an old school, great working fridge. I dont have temps from the fridge but at one stage it was so cold that the beer in the lines was frozen!! I put my first brew down, the Coopers Mexican. It all went well, even pouring. I have now a Coopers Lager and its impossible to pour. 60% froth. I am unsure if I have over carbonated (even though I didnt do anything different than before). I have been reading through forums and maybe my lines are wrong?? I have 6mm lines which are both under 1m in length. I have been reading that 5mm is the way to go and length can play big part. Although my last brew was perfect. Any advice/help would be much appreciated.

Thanks in advance

Lisa :D
User avatar
warra48
Posts: 2082
Joined: Wednesday Apr 04, 2007 12:45 pm
Location: Corlette NSW

Re: Frothy Beer

Post by warra48 »

Hi Lisa,

Welcome to this forum.
I have always bottled my brews, so I am unfortunately of no help to you. However, there are plenty on here who will be able to give pointers to resolve your issue.
barls
Posts: 199
Joined: Thursday Apr 07, 2011 11:08 pm

Re: Frothy Beer

Post by barls »

First off we need temps and pressures to comment. mine sits at 6 degrees and 70 on the inner scale
Works fine
User avatar
Pogierob
Posts: 220
Joined: Monday Jul 01, 2013 6:45 pm

Re: Frothy Beer

Post by Pogierob »

If it is over carbed then you need to let it go flat without exposing it to oxygen so basically turn off your gas and keep giving the pressure release valve every so often until it's flat. Then start again.

You can't over carb if you set it to pouring pressure and leave it for a week or so. Trick is working out your pouring pressure.
I can't help cause for safety against little kids my tap goes straight onto the keg. No hose.
hyjak
Posts: 147
Joined: Tuesday May 12, 2009 5:45 pm
Location: Hobart, Tas

Re: Frothy Beer

Post by hyjak »

You probably got this all sorted but for future forum users. Your lines are too short, you need to slow the beer down through the lines longer runs of hose will acheive this.
There are numerous calculators/spreadsheets about with the technical information if needed.
droverz
Posts: 2
Joined: Monday Nov 18, 2013 3:38 pm

Re: Frothy Beer

Post by droverz »

Hi All

Thanks for your help. I have got new, thinner and longer lines. All seems to working well now.
Post Reply