G'day Gentlemen,
Well, my power bill went up heaps this summer, so the large fridge with the 2 kegs, 1 spare keg as well and gas bottle inside will have to be converted to a brew fridge. That'll still cost me just not as much
Anyway, I have a smaller fridge that will just fit the 2 kegs (measured it) and taps, gas put outside the fridge, but I need to rub off the slots where the shelves used to be. The shelves fitted into moulded plastic.
To my question, if I rub them back with the belt sander and the foam becomes exposed when it is flat, how should I seal it?
I was thinking fibreglass as I have used this before and I thought that it would withstand the cold.
Anyone tried this?
Cheers
Boonie