waxy stuff inside fermenter

General homebrew discussion, tips and help on kit and malt extract brewing, and talk about equipment. Queries on sourcing supplies and equipment should go in The Store.
Post Reply
melbourne man
Posts: 195
Joined: Thursday Jun 01, 2006 11:42 am
Location: Melbourne

waxy stuff inside fermenter

Post by melbourne man »

i've just bottled a ginger beer that was in the fermenter for more than a month. there is a line going around where the krausen was and i can't remove it. it's sticky and waxy and if i try to wipe it off it just spreads out. can i scratch it off or is there a better way? what has caused this.

i always get a line where the krausen was but it normally comes off with a bit of brewing detergent and water.
Pale_Ale
Posts: 1233
Joined: Wednesday Oct 25, 2006 10:46 pm
Location: Adelaide, SA

Post by Pale_Ale »

NEver had waxy before, but I would try boiling water swished around. This will give you the heat and the movement. After swishing if still not gone use a chux and try wiping it off once it's hot. It should come off...
Coopers.
vitalogy
Posts: 142
Joined: Wednesday Nov 23, 2005 11:58 am
Location: Launceston, Tasmania
Contact:

Post by vitalogy »

Try a few teaspoons of neo-pink or similar, fill with hot tap water and let sit for 4-5 hours. I'd reckon that would lift it off.
User avatar
rwh
Posts: 2810
Joined: Friday Jun 16, 2006 1:47 pm
Location: Melbourne, Australia
Contact:

Post by rwh »

Hot water, alkaline salts/napisan/diswasher detergent, rubber gloves, green plastic scourer, elbow grease.

Do not scratch the inside of your fermenter, as this would provide nice safe homes in which bacteria could hide from your sanitisation agents.
w00t!
anthony
Posts: 33
Joined: Sunday Dec 17, 2006 9:08 pm
Location: Sidny

Post by anthony »

Just take care with the green plastic scourers - I buy the Scotch Brite but once did an experiment before using it on a non-stick pan. Used a damp one and very firmly rubbed some glass... the scotch brite ones will scratch both glass and stainless steel when you rub hard... shame cause they work so well getting muck off. Maybe other brands are not so abrasive.
chris.
Posts: 912
Joined: Wednesday Feb 08, 2006 3:28 pm
Location: Brewing
Contact:

Post by chris. »

I agree. Soak. Don't Scrub.
Last edited by chris. on Thursday Oct 11, 2007 8:09 pm, edited 1 time in total.
afromaiko
Posts: 133
Joined: Wednesday Oct 11, 2006 6:36 pm
Location: Melbourne, Australia

Post by afromaiko »

Dilute bleach solution or similar. You could make it a little stronger that what's normally used for disinfecting and it shouldn't do any harm. You can get some Home Brand baby bottle wash from the supermarket that should do the trick too.

Bleach is great at eating gunk. Try dropping a cap full or so in your dunny every now and then if you are too lazy to scrub it :oops: Wait 30 mins and it'll be sparkling.

Generally filling & soaking your fermenter even in plain water for a little while will make it easier to remove even with a standard sponge. Those plastic scourers work ok too, just don't scrub too hard.
User avatar
KEG
Posts: 1682
Joined: Thursday Dec 21, 2006 9:02 am

Post by KEG »

afromaiko wrote:Bleach is great at eating gunk. Try dropping a cap full or so in your dunny every now and then if you are too lazy to scrub it :oops: Wait 30 mins and it'll be sparkling.
:lol: :lol: :lol:

i do that too! :lol:
Image
anthony
Posts: 33
Joined: Sunday Dec 17, 2006 9:08 pm
Location: Sidny

Post by anthony »

There is a scourer by Selleys called wash up WIZ that will not scratch. Never seen it in a supermarket (looked real hard) but you can get it at bunnings in the houshold cleaning section. Absolutely amazing product... lasts forever and works a treat.
melbourne man
Posts: 195
Joined: Thursday Jun 01, 2006 11:42 am
Location: Melbourne

Post by melbourne man »

i tried soaking over night in bleach solution but it wouldn't come off so i tried boiling water and that didn't work. i had to use a green plastic scourer and a bit of elbow grease
vitalogy
Posts: 142
Joined: Wednesday Nov 23, 2005 11:58 am
Location: Launceston, Tasmania
Contact:

Post by vitalogy »

Bloody hell, can't believe the bleach didn't take it off. Wonder what it was. Being a ginger beer, I wonder if it's the artificial sweetener they use in it that could have been a bit sticky?
User avatar
gregb
Moderator
Posts: 2620
Joined: Saturday Sep 25, 2004 9:12 am
Location: Sydney

Post by gregb »

If bleach didn't clean it up then give vitalogy's tip a whirl.
vitalogy wrote:Try a few teaspoons of neo-pink or similar, fill with hot tap water and let sit for 4-5 hours. I'd reckon that would lift it off.
Cheers,
Greg
afromaiko
Posts: 133
Joined: Wednesday Oct 11, 2006 6:36 pm
Location: Melbourne, Australia

Post by afromaiko »

Would it be safe to try giving it a wipe over with metho?
User avatar
KEG
Posts: 1682
Joined: Thursday Dec 21, 2006 9:02 am

Post by KEG »

^^ i was thinking metho as well. it evaporates off clear if any is left behind anyway.
Image
User avatar
rwh
Posts: 2810
Joined: Friday Jun 16, 2006 1:47 pm
Location: Melbourne, Australia
Contact:

Post by rwh »

The "black and gold" green scourers are soft enough to not be very good at getting gunk off, so I feel OK using them on my fermenters. :lol:
w00t!
Noodles
Posts: 269
Joined: Friday Jul 21, 2006 2:34 pm
Location: Horsham, Victoria

Post by Noodles »

anthony wrote:There is a scourer by Selleys called wash up WIZ that will not scratch. Never seen it in a supermarket (looked real hard) but you can get it at bunnings in the houshold cleaning section. Absolutely amazing product... lasts forever and works a treat.
I second the use of the wash up Wiz, a great product. I get mine through my local Mitre 10, i've also never seen it in supermarkets.
"Doc, what can I do about these terrible hangovers?"
'You can stop drinking beer'
"No, seriously Doc, what can I do?"
Post Reply