I recently made a Stout loosely based on this recipe - http://www.grainandgrape.com.au/BeerOTM ... ersIRS.htm
I used,
1 Coopers Stout kit
1 Tooheys Lager kit (got a few of these real cheap)
~500g JW dark Crystal malt
~200g JW Wheat malt
Stout kit yeast.
Volume 21 litres.
It was my first attempt at using grains & would say it went OK. I had to use more water though (aprox 1.5l); the 500ml in the recipe hardy wet the grain. I also need a better filter than a cotton bandana & colander. Very slowly drained off the grain & added a bit more water when possible. Boiled the run off & let it cool while I added the kits to the fermenter.
I cooled & diluted both the kit & grain juice with pre-chilled water from the fridge. Pitched rehydrated kit yeast. Blew bubbles as Coopers yeast seem to do.
Bottled & stored out of sight for winter

Amber Ale
After making the above stout I had the grains still sitting in the colander on top of the mash pot. Some more liquid had drained out & collected in the pot. I tested this in the hydrometer & found it still had a fairly high gravity, about 1.040 for the 500ml or so that had slowly drained while I finished the stout. Too good to waste I thought. I put a bit more warm water over the grain & collected 2.5 litres of dark liquid. This went into the fridge to wait for the stout to finish & free up the fermenter.
1 Tooheys Draught kit (Just out of date, $3.15 each)
500g LDME
500g Dextrose
2.5 litres second runnings from stout.
10g Willamette boiled 5 mins.
10g Willamette at flame out.
Yeast starter from Coopers Pale Ale.
Tasted both starter & runnings to ensure no gremlins had grown in them. Boiled runnings & LDME added hops for 5 min boil, flameout & add aroma hops. While wort cooled, added kit & dextrose to fermenter, add cooled wort. Topped up with chilled water to 22 litres.
Pitched yeast starter at 21c. OG 1.045
Racked 6 days later, SG 1.006.
To be bottled this week-end.